On 05/11/2011 12:21 PM, Raymond Norton wrote: > The switch and server are only separated by another layer 3 > switch/router. Could there be filtering then ?? The same server can poll > other local switches. Do you know of a command I can issue on the switch > itself to be sure the community string is working? > Given that, the most likely possibility is that while you have the SNMP community configured, access on the switch to SNMP is still globally disabled. It would take me quite a while to find a better answer than that, so good luck. > > > On 05/11/2011 12:15 PM, Daniel Taylor wrote: >> On 05/11/2011 12:11 PM, Raymond Norton wrote: >>> I am trying to set up mrtg to monitor an HPProcurve >>> <http://www.tek-tips.com/viewthread.cfm?qid=1648083&page=1#> 2919al >>> switch that has a couple vlans on it. I can ping the vlan 1 ip 10.0.1.1, >>> but cfgmaker willmar at 10.0.1.1<mailto:willmar at 10.0.1.1> -output=config >>> times out, as well as snmpwalk -v 1, 2c, and 3 10.0.1.1 >>> >> Can you check to see if UDP-161 is being filtered? >> > -- Dan