-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 That's correct, once you've brought the system back up with the commands you listed, just continue where you left off. I don't always mount /dev or /proc in the chroot environment, and I've had it get a bit goofy once or twice, but usually it's fine without it. You could also try rmmod'ing and modprobe'ing the modules for your NIC. > -----Original Message----- > From: tclug-list-bounces at mn-linux.org > [mailto:tclug-list-bounces at mn-linux.org] On Behalf Of Samuel > MacDonald Sent: Tuesday, February 03, 2004 12:26 PM > To: TCLUG Mailing List > Subject: [TCLUG] Holy Cow Why Now! > > > The bootstrap finished I was doing the "emerge --fetchonly > system" but I got "-bash: emerge: command not found" > > I looked at the lights on the pig tail of my NIC (DARK!!!!) > > I tried configuring eth0 again using "net-setup eth0" but I get the > following > message after I put in the Gateway address. > > ++++++++++++++++++++++++++++++++++++++++++++ > SIOCSIFADDR: No such device > eht0: unknown intervace: No such device > Type "ifconfig" to make sure the interface was configured > correctly. ++++++++++++++++++++++++++++++++++++++++++++ > ============================================= > ifconfig > lo Link encap:Local Looopback > inet addr:127.0.0.1 Mask:255.0.0.0 > ... > ifconfig eth0 > eth0: error fetching interface information: Device not found > ============================================= > > What the heck do I do now? > Restart the computer and pickup where I left off? > I'm not sure what all needs to be done when I restart the > machine. I've made a list of what I think I need to do... > > Restart and configure the NIC again, then... > > 1. The file system is in place so I need to > # swapon /dev/hda2 > # mount /dev/hda3 /mnt/gentoo > # mount /dev/hda1 /mnt/gentoo/boot > # mount -t proc none /mnt/gentoo/proc > # mount -o bind /proc /mnt/gentoo/proc > > 2. I have all the files in place so I need to > # mount -o bind /dev /mnt/gentoo/dev > # chroot /mnt/gentoo /bin/bash > # env-update > # source /etc/profile > > 3. Then I can continue on ... > # emerge --fetchonly system > # emerge system > > 4.Continue with the install... > > Sam. > > _______________________________________________ > TCLUG Mailing List - Minneapolis/St. Paul, Minnesota http://www.mn-linux.org tclug-list at mn-linux.org https://mailman.real-time.com/mailman/listinfo/tclug-list -----BEGIN PGP SIGNATURE----- Version: PGP 8.0.3 iQA/AwUBQB/pvtRLIBm9yjm3EQKJjACgjxGxYbcDiIKYGgjBRMLtV5krtV0AoIsa ImiM25Laq3D8PQebF99sJ6Va =1OZj -----END PGP SIGNATURE----- _______________________________________________ TCLUG Mailing List - Minneapolis/St. Paul, Minnesota http://www.mn-linux.org tclug-list at mn-linux.org https://mailman.real-time.com/mailman/listinfo/tclug-list