> The problem is that when I do > that I'll lose LILO and therefore access to the slave drive/Linux. I've > gone thru this recently (about a month ago) after installing the new hd > and wound up reinstalling Linux on the slave drive because I didn't know > how to just re-do the LILO part of the Mandrake 9.1 install. > Any ideas on how I can 're-install' (?) LILO after the WIN98 install? I had a similar problem not too long ago. My solution was to use loadlin in my Win 98 partition (in DOS mode) to boot Linux from Windows. Once in Linux I reinstalled LILO. This was Slackware, so I used liloconfig at that point, but there should be a Mandrake equivalent. Not very artistic, but it did the job. A couple warnings: 1) Get a recent version of loadlin--older versions have trouble with new kernels. 2) Make sure you have your kernel copied to a safe place before you begin the process. Also make sure you know which is your root partition! Glenn McDavid mailto:gmcdavid at attbi.com http://www.winternet.com/~gmcdavid _______________________________________________ TCLUG Mailing List - Minneapolis/St. Paul, Minnesota http://www.mn-linux.org tclug-list at mn-linux.org https://mailman.real-time.com/mailman/listinfo/tclug-list